Employment 2011-Midland Tower Tower Tech (firstname.lastname@example.org Comtrain,Cpr,First Aid and TMobile Certified Duties included:VerizonMaintaince-Climbing of 400-500 ft guyed towers sweep and pim test verizon lines and antennas and replacing Antennas,TMAs,or lines depending on test results.Maintaining lighting systems on Verizon towers as well climb rig tower in cases where omni antennas were higher than beacon light had to raise beacon or invert omnis so that beacon light was highest part on tower.Changing several lighting systems from S/O to LED as well ..Sprint 4G ant T-mobile installs
xxx-xxx-xxxx Appalachian Contracting Company
Tower Erector (Site Superintendent)
Comscope and Andrew’s Certified
Duties included: Stacking of self supporters and monopoles, running and installation of lines and antennas, tower maintenance and inspections, blueprint reading, site layout, foundation, grounding, halo grounding, and trenching. Ability to set up and use transit, torches, as well as cad-weld. Operate: Track Hoe, Ram Hoe, Back Hoe, Bob Cat, Boom Truck, Forklift, Dozer, and Front- End Loader.
xxx-xxx-xxxx Body Guard
Duties include: Working with five to six man crew building approximately 100-125 truck bed liners per day, work with various tools including but not limited to air and electric routers.
Duties Include: Managing a team of five to six men while making sure that the PLC function properly on all molds. Maintaining all paperwork for oven which includes counting of total liners ran per day as well as percent of scrap rate.
Duties Included: Responsible for training a crew of approximately six to eight men and assist them for six to eight weeks, teaching each detail of part running.
xxx-xxx-xxxx A & S Steel
Duties Include: responsible for reading blue prints to make sure beams were correct length and width. Make correct placement of head and tail plates and support clips secured by a spot welder and of a blow torch to trim flanges. Use of an overhead crane to maneuverxxx-xxx-xxxx lbs. Support Beams from conrac welder to fit up table approximately 300-375ft.
|Last Resume Update||September 28, 2015|
|Resume File|| ATT_1435011835441_ATT_1419485852424_BryanGaylor.doc 29 kB|